Filter
Top Products
SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
11.3 Wireless Telephone Status Messages
Wireless Telephone status messages provide information about the NetLink e340/i640
Wireless Telephone's communication with the AP and host telephone system. The
following table summarizes the status messages, in alphabetical order.
Message Description Action
3 chirps Wireless Telephone is not able to
communicate with the best AP,
probably because that AP has no
bandwidth available.
None. This is only a warning, the
call will handoff to the best AP
once it becomes available.
Bad Config Some needed configuration
parameter has not been set.
Check all required Wireless
Telephone configuration
parameters for valid settings.
Bad ESSID The Wireless Telephone is
configured for “static ESSID” (as
opposed to “Learn once” or “Learn
always” and no ESSID has been
entered.
Enter an ESSID in the
configuration settings or change to
one of the “Learn” modes.
(battery icon), Low
Battery and beep
Low battery In call: the battery icon displays
and a soft beep will be heard when
the user is on the Wireless
Telephone and the battery charge
is low. User has 15–30 minutes of
battery life left.
Not in call: The battery icon
displays whenever the battery
charge is low The message Low
Battery and a beep indicate a
critically low battery charge when
user is not on the Wireless
Telephone. The Wireless
Telephone will not work until the
Battery Pack is charged.
Can’t Renew DHCP The functional code is not able to get
a lease renewal.
Configuration problem. Check the
gateway address in the DHCP
server.
Charging … The Wireless Telephone is charging
in the Desktop Charger.
No action needed.
Charge Complete The Wireless Telephone is now fully
charged.
No action needed.
Checking Code Wireless Telephone is contacting the
TFTP Server to determine if it has a
newer version of software that
should be downloaded.
None, this message should only
last for approximately one second.
If message remains displayed,
power off and contact SpectraLink
customer support.
Checking DHCP IP The Wireless Telephone is retrieving
DHCP information from the DHCP
server.
None. This is informational only.
PN: 72-1084-02-D.doc Page 41