Filter
Top Products
SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
6. Mitel Networks VoIP Integration Factors
This section describes the mapping between the emulated Mitel Networks 5220 IP Phone
and the NetLink e340/i640 Wireless Telephone.
Voice Messaging Access
Voicemail access is obtained through the Message key which is assigned on the Wireless
Telephone to
FCN + 3.
CODECs
The NetLink e340/i640 Wireless Telephone is compatible with the G.711 and G.729a/ab
CODECs. There is no setting required on the Wireless Telephone.
DHCP
Dynamic Host Configuration Protocol (DHCP) is a standardized protocol that enables
clients to be dynamically assigned with various configuration parameters, such as an IP
Address, subnet mask, default gateway, and other critical network configuration
information. DHCP servers centrally manage such configuration data, and are configured
by network administrators with settings that are appropriate for a given network
environment. The Wireless Telephone will search for Mitel Networks server
configuration in the vendor specific and site-specific options listed in the table below.
The Wireless Telephone will use the following DHCP options if DHCP use is enabled:
Option Meaning
1 Subnet Mask
3 Default Gateway
6 DNS Server
15 Domain Name
66 TFTP Server
151 NetLink SVP Server
152 SpectraLink OAI Gateway
128 Mitel TFTP Server address (not currently
used by Wireless Telephone)
129 Mitel PBX RTC IP address
130 String containing “MITEL IP PHONE”
siaddr Boot server or next server
TFTP
The Wireless Telephone uses TFTP to update the Wireless Telephone software over the
802.11b wireless LAN.
PN: 72-1084-02-D.doc Page 27