Filter
Top Products
SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
Message Description Action
Press End Call Your call has ended. Press the Power Off / End Call key
to return to standby mode.
Restart Command The Wireless Telephone received a
restart command from the supported
Mitel Networks VoIP solution.
None. The Wireless Telephone
will automatically restart in a few
seconds.
Select License The correct protocol has not been
selected from the license set.
Using the administrative menus,
select one license from the set to
allow the phone to download the
appropriate software.
Server Busy Wireless Telephone is attempting to
download from a TFTP Server that is
busy downloading other devices and
refusing additional downloads.
None, the Wireless Telephone will
automatically retry the download
every few seconds.
SKT Open Fail Socket open fail. Occurs when the
Wireless Telephone tries to connect
to the PBX but there is no response.
If resiliency is active, the Wireless
Telephone will keep trying.
If the PBX is inoperative and
resiliency is not active or the
Wireless Telephone cannot locate
a backup PBX, turn off the
Wireless Telephone and repair the
primary PBX. Note that it may be
advisable to reconfigure the
backup PBX to be the primary PBX
if the repair is more time-consum-
ing than the reconfiguration.
SVP Service Rej. The NetLink SVP Server has
rejected a request from the Wireless
Telephone.
The Wireless Telephone will restart
and attempt to re-register with the
SVP Server, which should fix the
problem. Report to your
administrator if it keeps happening.
System Locked
(with Busy Tone)
NetLink SVP Server is locked. Try call again later, system has
been locked for maintenance.
System Busy
(with Busy Tone)
NetLink SVP Server is busy or out of
resources.
All call paths are in use, try call
again in a few minutes.
TCP Rcv Timeout If the PBX has failed, this message
may display briefly as the Wireless
Telephone tries to connect to the
backup PBX in a resilient setting.
This message may be replaced by
the SKT Open Fail message if the
Wireless Telephone is unsuccessful
at connecting with the backup PBX
or if resiliency is not programmed.
Wait for the Wireless Telephone to
cycle through attempts to connect
to the backup PBX. See SKT Open
Fail above.
PN: 72-1084-02-D.doc Page 45