Uniden D1685 Cell Phone User Manual


 
English - 17
To... From the base From a handset
replay an earlier
message
During the first 2 seconds of a message,
press
PhonEbook.
select
1:Repeat
.
skip a message Press
cId
. Select
3:Skip
.
delete a
message
While a message is playing,
press
dElETE
. select
4:Delete
.
delete all
messages
With the phone in standby, press
dElETE
; press
dElETE
again to confirm.
Not available.
play old
messages
After the system plays all new messages,
press
PlaY/sToP
again. select
2:Play
.
stop playback Press
PlaY/sToP
. Select
5:Stop
.
Screening Your Calls
You can use the answering system for call screening. While the system takes a
message, you can listen on the base speaker (if you turn on
Call Screen)
or from
a handset. Only one handset can screen calls at a time. If another handset tries
to screen calls, it beeps and returns to standby.
To... From the base From a handset
hear the caller leaving a
message
Listen to the caller over
the speaker.
Press
MEssagE/MuTE
.
answer the call Press
sPEakEr
. Press
Talk/Flash
.
mute the call screen
without answering*
Press
PlaY/sToP
.
Press
End
or return the
handset to the cradle.
* If you mute the call screen, the system continues taking the message: it just stops
playing through the speaker.
Using the System While You're Away from Home
You can dial in to your answering system from any touch-tone phone. Before
you can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select
Ans. Setup
, then select
Security Code
. Use the number keypad to enter a two-digit security code (
01
to
99
). Press
MEnu/sElEcT
when you’re finished.
# Remember to make a note of your new security code!
Dialing In to Your System
1. Call your phone number & wait until the system answers. (If the system is
turned off, it answers after 10 rings & sounds a series of beeps.)