UTStarcom Handset Cell Phone User Manual


 
Getting Started
11
1.5.2 Charging the Battery
Connect the charger to a standard 100~240V AC wall outlet.
! LED Off: Battery not attached to phone
! LED Blinking fast (500msec): Battery problem. The battery
temperature is abnormal.
! LED Blinking slow (1sec on, 3 sec off): Battery is charging.
! Service Light: Charging completed
! Note: In case of a sudden electric power interruption, the travel
charger may not function properly. If this occurs, disconnect the
travel charger from the wall outlet, and try charging again after 5
seconds.
1.5.3 Battery Level Indicator
You can monitor the battery status by checking the battery level indicator.
The number of blocks indicates the battery’s condition as follows:
Full charge
Low charge
Flashing indicates discharged
1.5.4 Power Management
Battery Mode Talk Time Standby Time
Digital 160~210 min 45~140 Hours
Lithium Ion
800 mAh
Analog 70~90 min 11~13 Hours
The criteria of measurement are in accordance with our internal
specifications.
These operating times are for a new battery. Approximate values may vary
depending on network configuration, signal strength and handset usage.