Filter
Top Products
7
Getting Started
Existing
Network Router
Base Unit
INTERNET
DSL or Cable Modem
PC
WAN Port
Laptop
Handset 1 & 2
Installation With A Router
Installation Directions
Warning: Do not route the Ethernet cable to outdoors, and ensure that you are
using a safety approved DSL or Cable modem with proper electrical isolation.
STEP 1:
Using the blue Ethernet cable provided, connect one end into the blue port,
labeled “WAN,” located on the back of the IP8100 series broadband telephone
base unit and connect the other end into an available LAN port on your router. If
you have a wireless router, place the base unit at least three feet (36 inches) away
from your router to avoid interference.
Helpful Hint: If all the Ethernet ports on your existing router are full, disconnect
one of the attached devices from the existing router. Plug the blue Ethernet cable
into the now free port on your router. Connect the device you just unplugged
from your router to the yellow “PC/LAN” port located on the back of IP8100 series
broadband telephone base unit.
STEP 2:
Plug the power cord into the power port located on the bottom of your base unit
and the other end into the electrical outlet. This turns the broadband telephone
on.
Helpful Hint: Do NOT interrupt this registration process by unplugging the
power or by using the handsets until the READY indicator light on the front of
base has gone from flashing yellow to a steady green.
Helpful Hint: Use only the power cord provided in this package; using any other
power cord could damage the broadband phone.
NOTE: The IP8100 series telephone is expandable up to a
total of 4 handsets. Uses model IP811 (sold separately)