72 Raven CDMA User Guide for Verizon, version 2.23
Direct Communication
Direct Communication can be used with the Raven to contact other Internet devices
to pass information or other tasks.
*UDPLAST=n n=0 or 1 If enabled, sets S53 to the last accepted IP address
through UDP auto answer. This can be used in conjunc-
tion with MD3 so that when there is no UDP session,
new ethernet host data will cause a connection to be
restored to the last IP accepted through UDP auto
answer. .
0 : Does not change S53 setting. (Default).
1 : Set S53 to the last accepted IP.
Note: This does not change the S53 setting in NVRAM.
If the modem is reset, the original S53 setting will be
restored from NVRAM.
*USD=n n=1-255 Waits the specified delay before sending the first UDP
packet and the subsequent UDP packets out to the serial
port.
0 : No UDP packet delay (Default).
Delay in 100ms units, from 100 ms to 25.5 sec.
\Qn n=0 | 2 | 4 Set or query the serial port flow control setting.
0 : No flow control is being used.
1 : RTS/CTS hardware flow control is being used.
4: Transparent software flow control. Uses escaped
XON and XOFF for flow control. XON and XOFF char-
acters in data stream are escaped with the @ character
(0x40). @ in data is sent as @@.
\APPP none Set modem operation to PPP mode.
\ASLIP none Set modem operation to SLIP mode. DTR must be
asserted (&D0 or S211=1).
Caution: Not all AT Commands can be used while in PassThru
mode.
TABLE 6. Local Network and Host Modes
Command Parameters Details
