Test Mode Operation
7-8 Modem 3600
DTE Controlled Remote Digital Loopback (Pin 21) *RD
To enable DTE Controlled Remote Digital Loopback, enter *RD1.
Enabled, the modem goes into Remote Digital Loopback when it detects
an off-to-on transition of pin 21 while in the online data mode. The test
ends when it detects an on-to-off transition of pin 21 and then returns to
online data mode. To disable this function enter the *RD command.
If the test timeout option is enabled and pin 21 remains high,
the modem returns to online mode at the end of the test
timeout period and does not re-enter the test mode until an
off-to-on transition of pin 21 is detected.
DTE Controlled Local Analog Loopback (Pin 18) *LA
To enable DTE Controlled Local Analog Loopback Test, enter *LA1.
Enabled, the modem goes into local analog loopback when it detects an
off-to-on transition of pin 18. The test ends when it detects an on-to-off
transition of pin 18. To disable, enter *LA.
If the test timeout option is enabled and pin 18 remains high,
the modem returns to idle mode at the end of the test timeout
period and does not re-enter the test mode until an off-to-on
transition of pin 18 has been detected.
Command Operation
*RD Ignore pin 21
*RD1 RDL enabled (pin 21)
Command Operation
*LA Ignore pin 18
*LA1 LAL enabled (pin 18)
