Dell™ PowerEdge™ T610 Technical Guidebook
37
POWEREDGE T610
Category
Card
Priority
Description Dell PN
PCIe Link
Width
Slot
Priority
Max
Cards
Fibre Channel
8 HBA
19
QLogic QLE2562 FC8
Dual-Channel HBA
G44
4C
Gen2 x4
Slot 4, 5, 1,
2, 3
5
Fibre Channel
8 HBA
20
QLogic QLE2560 FC8
Single-Channel HBA
G42
5C
Gen2 x4
Slot 4, 5, 1,
2, 3
5
Fibre Channel
4 HBA
21
QLogic QLE220 FC4
Single-Channel HBA
YY0
04
Gen1 x4
Slot 4, 5, 1,
2, 3
5
1Gb NIC 22
Intel PRO/1000PT Gigabit
Copper Dual-Port NIC
(Redwater)
X39
59
Gen1 x4
Slot 4, 5, 1,
2, 3
5
1Gb NIC 23
Broadcom BCM5709C IPV6
Gigabit Copper Dual-Port NIC
with TOE and iSCSI Ofoad
(Dragony)
F16
9G
Gen1 x4
Slot 4, 5, 1,
2, 3
5
1Gb NIC 24
Broadcom BCM5709C IPv6
Gigabit Copper Dual-Port NIC
with TOE (Dragonwing)
G21
8C
Gen1 x4
Slot 4, 5, 1,
2, 3
5
Dell™ PowerEdge™ T610 Technical Guidebook
1
Thermal testing to determine if the PERC5 can be installed in other slots is pending.
2
A maximum of 2 nternal/external storage controllers (Dell PERC and SAS cards) are allowed in the system in addition to the integrated storage controller.
Note: The PowerEdge T610 supports up to 25W maximum power for the first two cards and up to 15W
for the third, fourth, and fifth PCIe cards regardless of which slots are populated (does not apply to the
Internal Storage Slot). This restriction applies to any PCIe cards that have a maximum power over 15W.
PCIe cards that are aected by this restriction are noted in the table above by an asterisk.
This list was generated based on thermal, mechanical, and performance inputs. Generally speaking,
thermal requirements were a priority for any card over 15W (PERC and most 10G NIC cards).
Performance considerations (e.g., matching link width to slot width) were factored in once both thermal
and mechanical constraints were met. In some cases, the performance considerations took priority
over thermals – this was done after consulting with the thermal team.
