A SERVICE OF

logo

Power Wash 250™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 11
2.1 Mounting
The POWER WASH 250B™ is fully operational in two different mounting
positions, hanging upside from a ceiling or set on a flat level surface. To avoid
internal damage to the unit, never mount the unit on its side as illustrated below.
Be sure this fixture is kept at least 0.5m away from any flammable materials
(decoration etc.). Install a safety cable that can hold at least 10 times the weight of
the fixture. Never use the carrying handles for secondary attachment.
Refer to regulations BGV C1 (former VBG 70) and DIN VDE
0711-217 for proper installation in Europe
To ensure proper installation, only qualified staff should
attempt installation.
2.1.1 Clamps
Secure two clamps to the bottom of the POWER WASH 250B™ to mount
the fixture to truss. Refer to the printed instructions on the bottom of the
fixture for proper clamp installation.
2.1.2 Mounting plate
For a permanent installation of the POWER WASH 250B™ in a non-truss