118
MR-8HD Owner’s Manual (Part editing)
5) Press the [MENU/ENTER] knob.
The display now returns to the part edit menu
screen, where “Paste Part >” is highlighted.
6) Press the [STOP] key to exit the menu mode.
<Note>:
If you are going to carry out the
paste operation when no data is pasted on
the clipboard, the error message (“Clip-
board Empty!) is shown on the display and
the MR-8HD does not accept the operation.
Press the [STOP] key to exit the menu mode
and copy the desired data to the clipboard
before carrying out the paste operation.
<Note>:
If you are not satisfied with the re-
sult, press the [UNDO/REDO] key to undo
the operation (see page 111).
3) Rotate the [MENU/ENTER] knob to select the
paste destination track(s), and press the
[MENU/ENTER] knob.
The display returns to the previous screen.
4) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8HD
completes the paste operation.
If you want to cancel the part paste operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] knob.
