72
MR-8HD Owner’s Manual (Track bouncing)
The MR-8HD can mix input signals of [INPUT A] through [INPUT D]. The following diagram
shows an example of mixing signals of INPUT A through INPUT D when bouncing tracks 1 through
6 to tracks 7/8. As you can see, the signals of INPUT A through INPUT D are mixed to the L/R
stereo buss together with the bounced signals.
Before starting track bouncing, connect the
desired sound source(s) to any desired
input(s) between INPUT A and INPUT D.
Connecting sound sources to INPUT A through INPUT D
Adjust the input level of each input using the
[TRIM] control to match the balance with the
bounced track levels.
Also, you can adjust panning of each input
for stereo mix. See the next page for details
about how to set panning.
To mix the input signal of an input channel
(any of INPUT A through INPUT D) to the L/R
stereo buss, turn on the corresponding [TO
STEREO BUSS ON/OFF] switch.
[TO STEREO BUSS ON/OFF] key setting
MIN
MAX
LINE MIC LINE MIC LINE MIC LINE MIC
BAL
BALBAL
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
PEAK
DISTORTION
GUITAR
/GUITAR
INPUT A SELECT
INSERT
BAL
UNBAL
TRIM
INPUT A
INPUT B INPUT C INPUT D
ON/
OFF
TO STEREO BUSS
ON/
OFF
ON/
OFF
ON/
OFF
[TRIM] control
MIN
MAX
LINE MIC LINE MIC LINE MIC LINE MIC
BAL
BALBAL
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
PEAK
DISTORTION
GUITAR
/GUITAR
INPUT A SELECT
INSERT
BAL
UNBAL
TRIM
INPUT A
INPUT B INPUT C INPUT D
ON/
OFF
TO STEREO BUSS
ON/
OFF
ON/
OFF
ON/
OFF
[TO STEREO BUSS ON/OFF] key
When the [TO STEREO BUSS ON/OFF] key is
turned on, the key illuminates in green. That
is, when the key illuminates, input signal is
sent to recording tracks. (Note that when the
key flashes, the corresponding input is as-
signed to any recording track.)
Trk 4
Trk 3
Trk 2
Trk 1
Mastering Effects
Trk 5
Trk 6
Mixing
Playback
Reverb
or
DElay
Bouncing
Trk 7
Trk 8
STEREO OUT (L, R)
INPUT A
INPUT B
INPUT C
INPUT D
TRIM
Playback
Playback
Playback
Playback
Playback
Record
Record
<Note>:
If you press the [TO STEREO BUSS ON/OFF] key when make recording other than track bouncing, the
key lamp may flash. This shows the input signal is routed to the armed track. That is, the input signal will be
recorded to the armed track, in stead of mixed to the stereo buss.
Mixing signals of inputs A through D
