73
MR-8HD Owner’s Manual (Track bouncing)
The default panning settings are as below.
You can set each input to the desired panning
position from L10 (hard left) to R10 (hard
right).
Input A
CNT (center position)
Input B
CNT (center position)
Input C
CNT (center position)
Input D
CNT (center position)
3) Rotate the [MENU/ENTER] knob to select the
desired item (any one of "Input A Pan" through
"Input D Pan"), and press the [MENU/ENTER]
knob.
The display shows the screen for making
panning setting of the selected input.
The current setting flashes.
In the screen example below, "Input A Pan" is
selected and the default "CNT" is flashing.
You can select the desired panning value from
among R01 through R10 and L01 through L10,
as well as "CNT" (center).
4) Rotate the [MENU/ENTER] knob to select the
desired value, and press the [MENU/ENTER]
knob.
The panning is set and the display returns to
the previous screen.
In the screen example below, "Input A Pan" is
set to "R10".
You can also make panning setting of another
input in the same manner as above.
5) Press the [STOP] key to exit the menu mode.
By selecting "<< Back" and pressing the [NETER]
key, the display returns to the previous screen.
Therefore, you can also exit the menu mode
by repeating this operation.
<Tip>: You can directly access to the in-
put menu screen by a long press of the
[TO STEREO BUSS ON/OFF] key of the
desired input channel. On the input menu
screen accessed in this way, the panning
setting item for the corresponding input
is highlighted.
For example, a long press of the [TO STE-
REO BUSS ON/OFF] key of [INPUT D] di-
rectly accesses to the screen shown be-
low.
Panning setting for INPUT A through INPUT D
1) While the recorder is stopped, press the
[MENU/ENTER] knob to enter the menu mode.
The display now shows the first page of the
menu selection screen.
2) Rotate the [MENU/ENTER] knob to select "Input"
on the second page, and press the
[MENU/ENTER] knob.
The display now shows the input menu screen.
You can independently set panning for each of INPUT A through INPUT D. Each input signal is
positioned in the mix according to the panning setting here.
