English - 30
INSTALLATION
If the guide wire has to be installed on a steep
slope, it is an advantage to lay the wire at an
angle to the slope. This makes it easier for the
robotic lawnmower to follow the guide wire on
the slope.
Avoid laying the wire at sharp angles. This can
make it difcult for the robotic lawnmower to follow
the guide wire.
6. Run the guide wire to the point on the boundary
loop where the guide wire is to be connected.
Lift up the boundary wire. Cut the boundary
wire using for instance a pair of wire cutters.
Connecting the guide wire is made easier if an
eyelet has been made on the boundary wire as
outlined in the previous description. See Eyelet for
connecting the guide wire on page 25.
7. Connect the guide wire to the boundary wire using
a coupler:
Insert the boundary wire in each of the holes in
the coupler. Insert the guide wire in the centre
hole in the coupler. Check that the wires are fully
inserted into the coupler so that the ends are
visible through the transparent area on the other
side of the coupler.
Use pliers to completely compress the button on
the coupler.
It does not matter which holes are used to
connect each wire.
8. Staple down/bury the splice in the lawn.
IMPORTANT INFORMATION
The guide wire may not cross the bound-
ary wire, for instance a boundary wire that
is laid out to an island.
135º
135º
90º
3012-953
3012-954
3018-061
3018-055
3018-073
