English - 77
TROUBLESHOOTING
Outside working area The boundary wire connections to
the charging station are crossed.
Check that the boundary wire is connected
correctly.
The boundary wire is too close to the
edge of the working area.
Check that the boundary wire has been laid
according to the instructions. See 3 Installation
on page 15.
The working area slopes too much
by the boundary loop.
Check that the boundary wire has been laid
according to the instructions. See 3 Installation
on page 15.
The boundary wire is laid in the
wrong direction around an island.
Check that the boundary wire has been laid
according to the instructions. See 3 Installation
on page 15.
Disturbances from metal objects
(fences, reinforcement steel) or
buried cables close by.
Try moving the boundary wire.
The robotic lawnmower nds it hard
to distinguish the signal from an
installation close by.
Place the robotic lawnmower in the charging
station and generate a new loop signal.
See 6.5 Security on page 45.
Wrong PIN code Wrong PIN code has been entered.
Five attempts are permitted, and
the keypad is then blocked for ve
minutes.
Enter the correct PIN code. Contact the local
dealer if you forget the PIN code.
No drive The robotic lawnmower has got
caught in something.
Free the robotic lawnmower and rectify the
reason for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before
using the robotic lawnmower.
The working area includes a steep
slope.
Maximum guaranteed slope is 45%. Steeper
slopes should be isolated. See 3.4 Installation
of the boundary wire on page 21.
The guide wire is not laid at an angle
on a slope.
If the guide wire is laid on a slope, it must be
laid at an angle across the slope. See 3.6
Installation of the guide wire on page 28.
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and the robotic lawnmower has made
a number of attempts to charge.
Put the robotic lawnmower in the charging
station and check that the charging strips
and contact strips make good contact.
An object is obstructing the robotic
lawnmower.
Remove the object.
Stuck in charging
station
There is an object in the way of the
robotic lawnmower preventing it from
leaving the charging station.
Remove the object.
Upside down The robotic lawnmower is leaning too
much or has turned over.
Turn the robotic lawnmower the right way up.
Needs manual
charging
The robotic lawnmower is set to the
Secondary area operating mode.
Place the robotic lawnmower in the charging
station. This behaviour is normal and no action
is required.
Next start hh:mm The timer setting prevents the robotic
lawnmower from operating.
Change the timer settings. See 6.3 Timer on
page 42.
