2.1.4 RAID1/SAFE
The two drives were connected to the products HDD1 and HDD2 Connector;
USB&Power Cable were connected;
Opening the power switch, pulling MODE switch to RAID1 and press RESET
switch, after a few seconds, the computer will automatically capture USB devices
and increased 2 drives(If not drive there, then the hard
disk drive management
will re-zoning which format),At the moment you can Operate the disk. Re-zoning
which drives formatted as follows(All information will be eliminated when Format
hard drives);
Click “My Computer”, right-clicking pop-up menu, click Options “manage”, pop-
up computer management plan was pop-up as follow:
Click “Disks Management” plan
:
Right pop-up The additional disks (H :) and the additional disks (F :)' menus,
choose “Delete Disk Segmentation”.
Click “Segmentation additional disks”, followed by a clew to operate
9
