Attention:
1. If you use two HDD simultaneously and discover that the LED1 or LED2
glittering by alternate blue & red lights for a long time. Please check and see
whether the HDD has installed correctly or not.
2. If you use two HDD simultaneously, and the HDD is damaged under RAID0,
JBOD, and BIG patterns. The data in the HDD would lose. Under the RAID1
pattern, you may consider to take out the damaged HDD and replace it with a
formatted HDD. The 5744 software has the“ REBUILDING” function which can
start recovering and return the losing data.
2.1 USB Interface
2.1.1
JBOD MODE
The two drives were connected to the products HDD1 and HDD2 Connector.
USB&Power Cable were connected;
Opening the power switch, pulling MODE switch to JBOD and press RESET
switch, after a few seconds, the computer will automatically capture USB devices
and increased 2 drives(If not drive there, then the hard
disk drive management
will re-zoning which format),At the moment you can Operate the disk. Re-zoning
which drives formatted as follows(All information will be eliminated when Format
hard drives).
Click “My Computer”, right-clicking pop-up menu, click Options “manage”, pop-
up computer management plan was pop-up as follow:
6
