A SERVICE OF

logo

57
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
10
SEC
10.1
SEC
10.2
TRUSS & ROOF INSTALLATION
3 ADULTS REQUIRED FOR STEPS 10.1 - 10.8
Interior Upward View
Place the ends of a Truss Assembly into the notches on the Wall Panels as shown. While one adult holds the
Truss Assembly in place, set a Roof Panel for Domed Skylight Assembly ONTO THE4RUSS!SSEMBLYAND&RONT'ABLE
The edge of the Roof Panel fits down inside the Truss Channel. Roof Panels and Roof Panels for Domed Skylights are
interchangeable; you may place them in any Roof Panel position.
Ensure the alignment nub in the Roof Panel fits into the notch on the Truss (this helps to align the holes in the
2OOF0ANELWITHTHOSEINTHE4RUSSTHE7ALL0ANELAND'ABLE
Alignment Nub
& Notch
Note: Ensure to carefully read and follow the roof installation instructions and notes. Following each
step in the order listed will minimize potential complications during installation.
Note: The edge of the Roof Panel fits into the Truss Assembly.
!
!
NO HARDWARE REQUIRED FOR THIS STEP