A SERVICE OF

logo

Open as PDF
next previous
69
12
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
SEC
Remove the plastic protective fi lm from both sides of the Window (AHE) and slide the Window into the grooves along
the sides of the opening in the Window Wall Panel (Fig. 1). Insert the #10 x 3/8” Pan-Head Screw (ADY) into the hole
ATTHEBOTTOMOFTHE7INDOW&IGUNTILmUSH!TTACHAWindow Latch (AIS) above each corner of the Window as
shown. When tightening the four (4) 1/4” x 5/8” Pan-Head Screws (ADZ), ensure the Window Latches slide freely (Fig.
$ONOTOVERTIGHTEN
AHE
ADY
AIS
AIS
ADZ
ADZ
Fig. 1
Fig. 2
Fig. 3
WINDOW INSTALLATION
Note: Insert Window with bent edge at top and pointing away from the wall.
!
ADZ (x4)
ADY (x1)
AISX
(Not to scale)
ADZ
AIS
12.1
12