SYSTEM SETUP
4 - 5
Setting Handset Volume
Please carefully read “Choosing the Handset Volume,” page 4-4 before
you do the following steps:
1
Press
Features
,
1
,
1
,
7
.
2
If none of the users are
AMPLIFY VOL:ON?
SELECT <- -> & SET
hearing-impaired, press or
to select AMPLIFY VOL:OFF?
and press
Enter/Yes
, then go to Step 4
—OR—
If some or all of the users
are hearing-impaired, select
AMPLIFY VOL:ON? and press
Enter/Yes
.
3
If all the users are hearing-impaired,
PERMANENT?
SELECT <- -> & SET
press or to select PERMANENT?
and press
Enter/Yes
—OR—
If only some of the
TEMPORARY?
SELECT <- -> & SET
users are hearing-impaired, select
TEMPORARY? and press
Enter/Yes
.
4
Press
Stop
to exit.
Setting the Speaker Volume
You can adjust the speaker volume when your machine is on
Manual Telephone/Fax
.
Press Volume
or to adjust the volume level. The display shows the
setting you are choosing. Each key press changes the volume to the next
setting. The new setting will remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your machine is idle. You can turn
the ring OFF or you can select a ring volume level.
Press Volume
or to adjust the volume level. With each key press, the
machine rings as you hear the current setting and the display shows the
setting you are choosing. Each key press changes the volume to the next
setting. The new setting will remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the SYSTEM SETUP, RX
SETTINGS, DIALER SETTINGS and REMOTE FAX OPTIONS, plus the
COVER SHEET and COVER MESSAGE (from TX SETTINGS) features
are stored permanently. You may have to reset the date and time.
