A SERVICE OF

logo

7-12 COOLING AND LUBRICATION SYSTEM
Remove the mechanical seal ring 4 and rubber seal 5 from
the impeller.
Remove the impeller shaft 6 and washer 7.
Remove the mechanical seal with the special tool.
09921-20240: Bearing remover set (12 mm)
NOTE:
If there is no abnormal condition, the mechanical seal removal is
not necessary.
Remove the oil seal using a suitable bar.
NOTE:
If there is no abnormal condition, the oil seal removal is not nec-
essary.
The removed mechanical seal must be replaced with a
new one.
The removed oil seal must be replaced with a new one.