A SERVICE OF

logo

Open as PDF
next previous
Table 7-1
Tasks that are involved in adding a node to a cluster (continued)
ReferenceTask
See“Preparingforamanualinstallationwhenaddinganode”
on page 123.
See “Installing VCS RPMs for a manual installation”
on page 124.
Install the software
manually.
See “Adding a license key” on page 125.Add a license key.
See “Settingup the nodeto runin secure mode”on page 126.Fora cluster that is
running in secure mode,
verifytheexistingsecurity
setup on the node.
See “Configuring LLT and GAB” on page 128.Configure LLT and GAB.
See “Adding the node to the existing cluster” on page 130.Add the node to the
existing cluster.
See “Starting VCS and verifying the cluster” on page 131.Start VCS and verify the
cluster.
Setting up the hardware
Figure 7-1 shows that before you configure a new system on an existing cluster,
you must physically add the system to the cluster.
Adding and removing cluster nodes
Adding a node to a cluster
122