A SERVICE OF

logo

5 - 75
ENG
3. Tighten:
middle driven shaft bearing housing bolts
NOTE:
@
Before tightening the bolts:
1. Adjust the middle gear backlash.
Refer to “ADJUSTING THE MIDDLE GEAR
BACKLASH”.
2. Check that the middle driven gear turns
smoothly.
T
R
.
.
25 Nm (2.5 m · kg)
EAS00449
MEASURING THE MIDDLE GEAR
BACKLASH
1. Measure:
middle gear backlash
Out of specification Refer to “ADJUST-
ING THE MIDDLE GEAR BACKLASH”.
▼▼▼ ▼▼▼ ▼▼▼ ▼▼▼ ▼▼▼ ▼▼▼ ▼▼▼
a. Install the gear lash measurement tool 1
as shown.
b. Make sure the dial gauge plunger contacts
the measuring point a on the middle gear
backlash band as shown.
a
: 38 mm
c. Hold the middle drive shaft 2.
Middle gear backlash
0.10 ~ 0.20 mm
Gear lash measurement tool
90890-01467
MIDDLE GEAR