A SERVICE OF

logo

5 - 77
ENG
NOTE:
@
Tighten the middle driven shaft bearing
housing bolts carefully, one thread turn at a
time only. Push in the middle driven shaft
bearing housing and then tighten the bolts to
specification.
Clearance between the crankcase and the
middle driven shaft bearing housing should
be approximately 2 mm, when measured
with a thickness gauge
1
.
4. Hold the middle drive shaft
1
.
5. Turn:
middle driven shaft
NOTE:
@
While carefully tightening the middle driven
shaft bearing housing bolts in stages and in a
crisscross pattern, turn the middle driven shaft
back and forth until the dial gauge reads 0.10 ~
0.20 mm.
6. Measure:
crankcase-to-middle-driven-shaft-bearing-
housing clearance
(with a thickness gauge)
MIDDLE GEAR