Chapter 45 Introducing Commands
ES-4124 User’s Guide
370
redistribute
rip metric-type
<1|2> metric <0-
65535>
Sets the Switch to learn RIP
routing information which will
use the specified metric
information.
13
redistribute
static metric-
type <1|2>
metric <0-
65535>
Sets the Switch to learn static
routing information which will
use the specified metric
information.
13
passive-iface
<ip-addr/bits>
Sets the interface to be passive.
A passive interface does not
send or receive OSPF traffic.
13
rip Enables and enters the RIP
configuration mode.
13
exit Leaves the RIP configuration
mode.
13
vrrp network <ip-
address>/<mask-
bits> vr-id <1-7>
uplink-gateway
<ip>
Adds a new VRRP network nd
enters the VRRP configuration
mode.
13
exit Exits from the VRRP command
mode.
13
inactive Disables the VRRP settings. 13
interval
<1..255>
Sets the time interval (in
seconds) between Hello
message transmissions.
13
name <name
string>
Sets a descriptive name of the
VRRP setting for identification
purposes.
13
no inactive Activates this VRRP. 13
no preempt Disables VRRP preemption
mode.
13
no primary-
virtual-ip
Resets the network to use the
default primary virtual gateway
(interface IP address).
13
no secondary-
virtual-ip
Sets the network to use the
default secondary virtual
gateway (0.0.0.0).
13
preempt Enables preemption mode. 13
primary-
virtual-ip <ip>
Sets the primary VRRP virtual
gateway IP address.
13
priority <1-
254>
Sets the priority of the uplink-
gateway.
13
secondary-
virtual-ip <ip>
Sets the secondary VRRP
virtual gateway IP address.
13
service-
control
ftp <socket-
number>
Allows FTP access on the
specified service port.
13
Table 141 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
