Filter
Top Products
STAmEn
.Placing Calls
To Place a Call
1. Enter the phone number.
(A maximum of 32 digits will
be displayed.)
Turning the Phone On/Off
Press ~ for more than one second. All the indicators
and the digit display will light momentarily, and a tone will
be heard. The indicator T will stay while the phone is
turned on.
To turn the phone off, press ~ for more than one sec-
ond.
Antenna Position
2. Press ca .
The ~ indicator will light.
The antenna can be used in its fully extended or fully re-
tracted position only. It is recommended that the antenna
should be fully extended for optimum performance and
signal strength or while operating in poor signal areas.
.To Correct a Number
Press ~ to clear the last digit.
Press and hold ~ to erase all the digits entered
.If the Call Fails to Go Through
Press (3. and ca to redial the number.
Receiving Signal Strength Indicator (Tilll)
To Terminate a Call
Press ~ .The ~ indicator will go out,
Last Number Redial
Press E) @.3 to recall the last number you dialed,
then press q:J .
See Call History on page 42 for details.
Battery Level Indicator
You can always monitor the battery charge condition
with the constant battery level indicator. The number of
blocks indicates the battery conditions as follows:
I(!'""~ Full charge
C-.il Low charge
" , "
:C-..:J ~ Flashing indicates discharged.
" I "
Power Management
To Dial the Last Number Received
Press E) ~ to dial the last number with Caller ID
you received, then press CEJ .
See Call History on page 42 for details.
Standby Time
up to
~
I Slim Battery
! (BTR-4500)
Mode I
COMA I
Talk Time
up to
190 min.
65min.
170 h
12h
Phonebook Dialing
Press E) and enter an address (01 to 99) to recall a
number from your phonebook, then press q:] .
See Phonebook Recall on page 31 for details.
Analog
The operating times are approximate values and may
vary depending on network configuration and handset
usage.
To Mute a Phone Conversation
Press G G to mute your conversation at any time
during a call. "Mute" will be displayed.
To return to normal conversation, press G G
again.
"6
17j
The number of lines indicates the Signal Strength in
your area. Four lines show the maximum level. The dis-
play will vary as you move with the phone. If the signal
is not strong enough to place a call, "No Service" will
appear on the LCD display.