Filter
Top Products
2. Installation procedures
2.7 Suspending the projector from a truss
WARNING: Never su spend more than two (2) projectors. Failure to do so can cause serious injury o r d eath.
Introduction
A projector ca n be suspended from a truss using rigging clamps. When a Bottom Carry Handle is installed on the projector, 8 slots
are available to mount rigging clamps. 4 slots are longitudinally oriented (reference 1, image 2-17) and 4 slots are trans versely
oriented (reference 2, image 2-17). Each s lot contains a rigging point (reference 3, image 2-17) of which the position in the slot can
be adjusted depending on the truss the projector is being suspended from. T he rigging clamps can be attached to those rigging
points, which allows an easy and fast phys ical setup of the projector in a hanging configuration.
1
2
3
Image 2-17
Necessary tools
• 17 mm open-end wrench
• 24 mm open-end wrench
How to suspend 1 projector from a truss?
1. Measure the center distance of the truss support bars as illustrated.
X mm
Image 2-18
2. Loosen the nuts of the rigging points (reference 1, image 2-19) a nd slide t hem on there place a ccording to the measured center
distance.
Tighten the nuts of the rigging points.
Warning: M ake sure the rigging points are symmetrically around the center of the Bottom C arry Handle to ensu re the balance
of the hanging projector.
Warning: M ake sure the rigging po
ints are tightened after adjus tment.
18
R5905106 TOP & BOTTOM CARRY HANDLE 28/06/2011