GE NX-7002 Cell Phone User Manual


 
LOCATION 4 EVENT SELECTION FOR REPORT CONTROL 1 BY PARTITION (16 segments, feature selection
data)
All events for report control 1 are enabled by default. Select the partition(s) to include in the
event report. Enabled events are formatted into one or more messages according to pre-
configured settings and sent to the selected report destination. Enable the Test Reports event
group if using the NX-7002 as backup to another auxiliary dialler.
Segment 1 Alarms (and Restores)
Segment 2 Open / Close
Segment 3 Bypass
Segment 4 Zone trouble
Segment 5 Power trouble (AC failure and Low Battery)
Segment 6 Siren & Line Fault
Segment 7 Test Report
Segment 8 Program, Download & Log full
Segment 9 Tamper
Segment 10 Short Circuit
Segment 11 Sensor Lost
Segment 12 Sensor Low Battery
Segment 13 Expander Trouble
Segment 14 Fail To Communicate
Segment 15 Zone Activity Monitoring
Segment 16 Reserved
LOCATION 5 DESTINATION SELECTION FOR REPORT CONTROL 2 (1 segment)
This location contains the report destination for report control 2. See location 1.
LOCATION 6 BACKUP DESTINATION SELECTION FOR REPORT CONTROL 2 (1 segment)
This location contains the backup report destination for report control 2. See location 2.
LOCATION 7 REPORT DELAY FOR REPORT CONTROL 2 (1 segment)
The delay in seconds before the NX-7002 GPRS module reports to report control 2. See
location 3.
LOCATION 8 EVENT SELECTION FOR REPORT CONTROL 2 BY PARTITION (16 segments, feature selection
data)
All events for report control 2 are disabled by default. See location 4.
LOCATION 9 DESTINATION SELECTION FOR REPORT CONTROL 3 (1 segment)
This location contains the report destination for report control 3. See location 1.
LOCATION 10 BACKUP DESTINATION SELECTION FOR REPORT CONTROL 3 (1 segment)
This location contains the backup report destination for report control 3. See location 2.
LOCATION 11 REPORT DELAY FOR REPORT CONTROL 3 (1 segment)
The delay in seconds before the NX-7002 GPRS module reports to report control 3. See
location 3.
NX-7002 Installation manual Page 15 09/02/05