Filter
Top Products
EXITING THE PROGRAM MODE
When all the desired changes in programming have been made, it is time to exit the program
mode. Pressing the [Exit] key will exit this programming level and then return to the “Select a
Module to Program” level. If no additional modules are to be programmed, pressing the [Exit]
key again will exit the program mode. If there is a module to be programmed, it may be
selected by entering its address followed by the [#] key (see Selecting the module to program
for more information). The procedure for programming these devices is the same as for the
control panel, except the locations will be for the module selected.
Note: Each time you exit programming mode, the modem restarts and reads the PIN
number, network operator and SMSC address number from the NX-7002 configuration.
Programming the NX-7002 via the LCD keypad
All steps required for programming are the same as the aforementioned LED keypad. The LCD
keypad display will prompt you for the data required. While in the programming mode, and
not in a location, the number in parenthesis is the location you were previously changing.
For example, if the display reads “Enter location, then # (5)”, it is reminding you that location 5
was the last location you programmed. Refer also to “Programming Data” which follows.
Programming data
Programming data is always one of two types. One type of data is numerical, which can have
values from 0-15 or 0-255 depending on the segment size. The other type of data, feature
selection data, is used to turn features on or off. Use the following procedures with these two
data types.
NUMERICAL DATA
Numerical data is programmed by using the numeric keys of the system keypad to enter a
number from 0-255. To view the data in a location, a binary process is used. With this process,
the LED’s for zones 1 through 8 are utilized, and the numeric equivalents of their illuminated
LED’s are added together to determine the data in a programming location. The numeric
equivalents of these LED’s are as follows:
Zone 1 LED = 1 Zone 2 LED = 2 Zone 3 LED = 4 Zone 4 LED = 8
Zone 5 LED = 16 Zone 6 LED = 32 Zone 7 LED = 64 Zone 8 LED = 128
Example: If the numerical data to be programmed in a location is “66”, press [6] - [6] on the
keypad. The LED’s for zone 2 and zone 7 will become illuminated indicating 66 is in that
location (2 + 64 = 66).
NX-7002 Installation manual Page 8 09/02/05