Filter
Top Products
LG-TD7130
23
LG-TD7130
22
Power Save Mode
When the phone is in an area without service for about
10 minutes, it stops searching for service and enters into
the Power Save Mode. When your phone activates this
feature, Power Save is displayed on your screen. The
phone automatically checks for service periodically or
you can check manually by pressing any key.
Making a Call
Every time you make a call, follow these steps:
1) Make sure that the phone is turned on. If not, hold
down for 2 seconds.
2) Type the phone number and then press .
If the phone is locked, type the lock code. The lock
code is '0000' by default.
3)
To end the call press .
Correcting Dial Errors
If you typed a wrong number, press the Key once
to delete the lastly typed digit, or Hold down the Key
for 2 seconds to delete all the typed digits at the
same time.
Turning the Phone On and Off
Turning the Phone On
1) Install a charged battery pack or connect the phone to an
external power source such as the cigarette lighter
charger.
2) Hold down the Key for 2 seconds until the LCD
screen flashes.
NOTE As any other communication device, avoid
any unnecessary contact with the antenna
while your phone is turned on.
Turning the Phone Off
1) Press and hold until display screen turns off,
then release the key.
Signal Strength
The quality of a call depends on the strength of the sig-
nal supplied by the operator. The phone shows its sig-
nal strength through bars, located at the left top of the
screen. If there are more bars (a maximum of six), the
phone holds more signal strength. If the signal strength
is not satisfactory, try to change the position of the
phone. If you are in a building, try to be near to a win-
dow, where the reception of the signal may be better.
In some places such as : tunnels, elevators, basements
and garages, there may be limitation of the signal sup-
plied by the operator.
Chapter 2 Basic Functions
Chapter 2
Basic Functions
*TD7130_eng 03/9/20 3:26 AM Page 22