Filter
Top Products
1. Engine Cover — Lift this cover to gain access to the
engine or electric motor.
2. — This switch is located on the
side of the engine cover. When activated it will shut
down the engine.
3. Latch — Use this latch to secure the engine
compartment enclosure.
4. — There is a sealed bearing on
each end of the mixing drum. Bearings are packed
and sealed at the factory and require no further
maintenance.
5. Mixing Paddles — This mixer uses plastic and rubber
mixing paddles for the mixing of plaster and mortar.
Always clean paddles after each use.
6. — This feature allows mixing bags to be
opened easily, therefore allowing the contents of the
bag to fall directly into the mixing drum.
7. Safety Grill — Provided for operator safety. This safety
grill is designed to keep hands and solid objects out of
the mixing drum when in use. This grill should be closed
at all times when mixer is in use. remove the
grill or grill opening bar. Keep the grill clean by washing
it down daily.
8. — There is a zerk grease
fitting on each end of the mixing drum. These fittings
lubricate the dumping mechanism. Lubricate both
fittings at least twice a week.
9. Mixing Drum — Drum capacity is 12 cu. ft (340 liters).
Mixing materials such as mortar and plaster are to be
placed into this drum for mixing. Always clean drum
after each use.
10. — These jack stands swivel out
to support the mixer.
11. Forklift Pockets — When lifting of the mixer is
required, use these fork lift pockets to lift the mixer.
Remember to insert the forks of the forklift a minimum
of 24 inches into the lift pockets.
12. — Use these jack
stands to adjust the mixer to the desired height.
13. Hydraulic Oil Filter — 10 micron hydraulic filter. Filters
out small particles that are harmful to the hydraulic
system.
14. Charcoal Canister — A container filled with activated
charcoal that traps gasoline vapors emitted by the fuel
system.A container filled with activated charcoal that
traps gasoline vapors emitted by the fuel system.
MIXER COMPONENTS