Filter
Top Products
7. Turn the engine ignition key (Figure 17) to the
position and hold it until the engine starts. When engine
starts, release the key, allowing it to return to the
position.
Figure 17. Engine Ignition Key
8. If the choke lever was moved to the "CLOSED" position
to start the engine gradually move it to the
position (Figure 18) as the engine warms up. If the
engine has not started repeat steps 1 through 6.
Figure 18. Choke Lever (Open)
9. Before the mixer is placed in to operation, run the
engine for several minutes. Check for fuel leaks, and
noises that would associate with a lose component.
10. To begin mixing, place the throttle lever (Figure 19) in
the “” position
.
Figure 19. Throttle Lever (Run)
O
F
F
O
N
S
T
A
R
T
1. Move the throttle lever to the IDLE position (Figure 20)
and run the engine for three minutes at low speed.
Figure 20. Throttle Lever (Idle)
2. After the engine cools, push the Start/Stop switch
on the engine cover inward to the “OFF” position
(Figure 21).
Figure 21. Start/Stop Switch (OFF Position)
3. Place the fuel shut-off lever (Figure 22) in the "OFF"
position.
Figure 22. Fuel Valve Lever (OFF)
1. Move the throttle lever quickly to the IDLE position, and
place the engine ON/OFF switch in the OFF position.
START/STOP
SWITCH
PUSH IN
TO STOP
STARTUP