Filter
Top Products
TROUBLESHOOTING
Symptom Possible Problem Solution
Blades will not rotate.
Worn or defective V-belt? Replace V-belt.
Adjustment lever mis-aligned?
Check position of adjustment lever.
Adjust if necessary.
Material load too heavy, exceeding
mixer capability?
Reduce amount of material being
mixed.
Object stuck inside mixing drum,
jamming paddle rotation?
Stop engine. Empty out drum
contents. Remove obstruction.
Improper engine speed? Check and adjust engine speed.
Material leaking from drum ends. Worn or defective paddle shaft seals? Replace seals.
Drum diffi cult to discharge (tilt).
Defective or worn drum support
brackets?
Apply grease to bracket or replace.
Blades adjusted too tight.
Adjust blades until they almost touch
side walls of drum.