Filter
Top Products
This section is intended to assist the operator with the
initial start-up of the mixer. It is extremely important that
this section be read carefully before attempting to use the
mixer in the field.
1. Place the engine fuel valve lever (Figure 11) to the
“” position.
Figure 11. Engine Fuel Valve Lever (ON
Position)
2. Move the throttle lever (Figure 12) away from the
slow position, about 1/3 of the way toward the fast
position.
Figure 12. Throttle Lever (1/3 Start Position)
3. Place the choke lever (Figure 13) in the “CLOSED”
position if starting a cold engine.
attempt to operate the mixer
until the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
STARTUP
Figure 13. Engine Choke Lever (Closed)
4. Place the choke lever (Figure 14) in the “”
position if starting a warm engine or the temperature
is warm.
Figure 14. Engine Choke Lever (Open)
5. Place the engine ON/OFF switch (Figure 15) in the
“” position.
Figure 15. Engine ON/OFF Switch (ON Position)
6. Pull the Start/Stop Switch, located on the engine cover,
outward to start the engine (Figure 16).
Figure 16. Start/Stop Switch (Start Position)
START/STOP
SWITCH
PULL OUT
TO START