Filter
Top Products
MAINTENANCE
Replace hydraulic oil filter (Figure 29) every 500 hours.
Hydraulic tank capacity is 12 gallons (45 liters). Refill with
any of the following hydraulic oil types. Shell Tellius 68,
Mobil DFE26 or Texaco Rand HDC.
Figure 29. Hydraulic Oil Filter
It is important that the drum interior is free of dried material.
Obstructions can cause the paddle blades to lock against
the drum resulting in sudden dump handle movement.
1. Stop the engine. Push the Start/Stop switch on the
engine cover inward to the “OFF” position.
2. Place the hydraulic paddle lever in "neutral" position
to disengage.
3. disconnect the spark plug wire before
cleaning the inside of the drum.
4. Place "Do Not Operate" tag on mixer.
5. Make sure the rear section of safety grate is connected
to the mixing drum.
6. At the end of each day’s operation, place mixer drum in
an upright position and spray inside of tub immediately
with water to prevent lumps of dried mortar or plaster
from forming and contamination of future batches. DO
allow a buildup of materials to form on the blades
or anywhere inside the drum.
7. Rotate mixer to dump position and remove debris.
8. Thoroughly clean the entire mixer, cabinet, and frame.
9. pour or spray water over the engine (Figure 30).
Figure 30. No Spraying of Water
10. When cleaning of the entire mixer is done, return mixing
drum to an upright position.
For storage of the mixer for over 30 days, the following is
recommended:
1. Drain the fuel tank completely, or add STA-BIL to the
fuel.
2. Run the engine until the fuel is completely consumed.
3. Completely drain used oil from the engine crankcase
and fill with fresh clean oil, then follow the procedures
described in the engine manual for engine storage.
4. Clean the entire mixer and engine compartment.
5. Place the mixing drum in the down position (mouth
facing downward).
6. Cover the mixer and place it a clean dry area, that is
protected from harsh elements.