Filter
Top Products
Installation
GB 13
Motor antenna configuration
If you have an antenna motor to control your satellite antenna, you
must configure the following settings.
• From the "Antenna/Satellite selection" menu, select option 3
"Motor Antenna Configuration" and press OK.
Type of motor
• Select SATSCAN (ASTRA) if you have a Nokia SatScan motor.
• Select DiSEqC (Hotbird) if the motor that you have is controlled
by DiSEqC commands.
LNB type
• Select the correct LNB type for your configuration, e.g.,
"Universal".
LNB offset voltage
If the cable from the antenna is very long, the voltage to the LNB
could be too low to change the polarization. You can increase the
voltage to the LNB by 0.5 V.
Predefined ASTRA-/HOTBIRD-channel
Select one of the predefined channels and adjust the antenna
until a TV picture from the predefined channel is visible on the
screen.
Adjusting the motor for ASTRA/HOTBIRD
To continue the installation, you must now determine the
angle to ASTRA 1 or HOTBIRD. The motor and the antenna
must be adjusted towards the ASTRA 1 satellites at 19.2°
East or HOTBIRD satellites at 13° East as this is the reference
setting. All other preprogramd satellite positions are
oriented relative to ASTRA 1 or Hotbird.
You must also mount the antenna in a suitable location
outdoors.
For more information, please read the separate installation
instructions for the SatScan or DiSEqC positioner.
East and West limit setup
NOTE: You only have to set one or both of these limits if the
antenna is prevented from reaching its East/West limit positions.
This could be the case, for example, if the antenna is mounted too
close to a wall or in any similar situation.
To set these limits, adjust the antenna using the cursor left/right
button.
• First, move the antenna to the east limit.
• Then, move the antenna to the west limit.
• Press OK to confirm all settings and carry out the channel search
procedure.