Filter
Top Products
Getting started
4 Copyright © 2004 Nokia. All rights reserved.
■ Charging the battery
1. Connect the lead from the
charger to the socket on the
bottom of your phone.
2. Connect the charger to an AC
wall socket.
The text Charging is displayed
briefly if the phone is switched
on. If the battery is completely
empty, it may take a few minutes
before the charging indicator
appears on the display or any
calls can be made.
The charging time depends on the
charger and the battery used. For
example, charging a BL-5C battery
with the ACP-7 charger takes up to 3
hours in standby mode.
■ Switching the phone
on and off
Warning: Do not switch the
phone on when wireless
phone use is prohibited or
when it may cause
interference or danger.
Press and hold the
power key .
If the phone asks for
a code, key in the
code (displayed as
****).
■ Normal operating
position
Use the phone only
in its normal
operating position.
Your phone has a
built-in antenna.
As with any other
radio transmitting
device, do not
touch the antenna
unnecessarily
when the phone is switched on.
Contact with the antenna affects
call quality and may cause the phone
to operate at a higher power level
than otherwise needed.
Not touching the antenna area
during a phone call optimises the
antenna performance and the
talktime of your phone.
■ Keypad lock (Keyguard)
You can lock the keypad to prevent
the keys being accidentally pressed.
Press (Menu or Unlock) and
then within 1.5 seconds to lock
or unlock the keypad.
An incoming call can be handled
normally. When you end or reject the
call, the keypad will automatically
be locked again.
For automatic keypad lock, see
Automatic keyguard on page 23.