Filter
Top Products
Using the menu
22 Copyright © 2004 Nokia. All rights reserved.
■ Settings
(Menu 5)
Personal short-cuts
You can add some specific functions
to your personal short-cut list and
activate them either in standby
mode by pressing the softkey (Go to)
or accessing the Go to menu. Refer
to Standby mode on page 1 and Go
to (Menu 12) on page 38.
Press Menu, and select Settings and
Right selection key settings.
To select the desired functions for
your personal short-cut list, select
Select Go to options and the list of
available functions is shown. Scroll
to the desired function and press
Mark to add it to the short-cut list.
To remove a function from the list,
press Unmark.
To rearrange the functions on the
list, select Organise Go to options
and the desired function. Press Move
and select where you want to move
the function.
Call settings
Anykey answer
Press Menu, and select Settings, Call
settings and Anykey answer. Select
On and you can answer an incoming
call by briefly pressing any key,
except , selection key
(Silence), and .
Automatic redial
Press Menu, and select Settings, Call
settings and Automatic redial. Select
On and your phone will make up to
10 attempts to connect the call after
an unsuccessful call attempt.
Speed dialling
Press Menu, and select Settings, Call
settings and Speed dialling. Select
On and the names and phone numbers
assigned to the speed dialling keys,
from to , can be
dialled by pressing and holding the
corresponding number key.
Automatic service update
Your phone is capable of receiving
updates to wireless services sent to
your phone by your service provider.
Press Menu, and select Settings, Call
settings and Automatic service
update to activate or deactivate.
Calling card
If you wish to use a calling card for
long distance calls, you can first save
your calling card information into
your phone. Your phone is equipped
to handle up to four calling cards.
Saving Calling card information
1. Press Menu, and select Settings,
Call settings and Calling card.
2. Type in the security code and
press OK.