Filter
Top Products
29
Multimedia messaging settings
Select Menu > Messaging > Options > Settings > Multimedia message and from
the following options:
Image size — to define the size of the image in a multimedia message as Small
(max. 160 x 120 pixels) or Large (max. 640 x 480 pixels). If you select Original, the
image is not scaled.
MMS creation mode — To set the phone to inform you if you try to send a message
that may not be supported by the recipient, select Guided. To set the phone to
prevent you from sending messages that are not supported, select Restricted. If
you select Free, message creation is not restricted, but the recipient may not be
able to view your message.
Access point in use — Select which access point is used as the preferred
connection for multimedia messaging.
Multimedia retrieval — To receive multimedia messages only when you are in your
home network, select Auto in home netw.. To always receive multimedia messages,
select Always automatic. To retrieve messages manually, select Manual. To not
receive any multimedia messages or advertisements, select Off.
Allow anon. msgs. > No — to reject messages coming from an anonymous sender
Receive adverts — to indicate whether you want to allow reception of multimedia
message advertisements
Receive report > Yes — to show the status of the sent message (Pending, Failed, or
Delivered) in Reports
Deny report sending > Yes — to deny sending delivery reports
Message validity (network service) — If the recipient of a message cannot be
reached within the validity period, the message is removed from the multimedia
message center. Maximum time is the maximum amount of time allowed by the
network for which the message remains valid.
E-mail settings
Before you use e-mail, you must configure an internet access point (IAP) and
define your e-mail settings correctly. Follow the instructions given by your e-mail
service provider and internet service provider.
Select Menu > Messaging > Options > Settings > E-mail > Mailboxes and a
mailbox. If no mailbox settings have been defined, you are asked if you want to
define the settings.