Filter
Top Products
12 Copyright © 2004 Nokia. All rights reserved.
Charging a Battery
Once placed in the phone, the battery is ready for
charging.
NOTE:
• Use only batteries and chargers approved
by the phone manufacturer.
• In some vehicles, the ignition must be on in
order to charge the phone with the ciga-
rette lighter charger.
1 Connect the lead from the charger to the bot-
tom of the phone.
2 Connect the charger to an AC wall
outlet. The battery indicator bar
will start to scroll.
The text Charging is briefly dis-
played if the phone is switched on.
You can use the phone while it is
charging.
NOTE: If the battery is totally flat, it
may take a few minutes before the
charging indication appears on the
display or any calls can be made.
If using the ACP-7 charger and either
the BLS-2, BLS-2H, BMS-2, BMS-2S,
BMS-2V batteries for the first time,
be sure to charge them at least 12
hours.
The charging time depends on the
charger and battery used. For exam-
ple, charging BLS-2 battery using
ACP-7 takes about 4 hours and using
ACP-9 about 2 hours.
Note: Charging times may be longer
in countries where there is major
fluctuation.
3 The battery is fully charged when the battery
indicator bar stops scrolling, and the text
Battery full is briefly displayed (if the
phone is on). Charging time depends on the
charger and battery used.
NOTE: For a full charge, let the phone
charge for about 2 hours.
4 Disconnect the charger from the AC outlet
and the phone.
If the text Not charging is displayed, charg-
ing has been suspended. Wait for a while, dis-
connect the charger, plug it in again and retry. If
charging still fails, contact your dealer.
For more information, see chapter ‘Reference In-
formation’ - ‘Battery Information’.
Switching the Phone On
and Off
Press and hold the key for a second.
If the phone asks for a PIN code:
The PIN code is usually supplied with the SIM
card.
• Key in the PIN code, which is displayed as as-
terisks, and press OK.
See also ‘Reference Information - Access
Codes’.
If the phone asks for a security code:
• Key in the security code, which is displayed as
asterisks, and press OK.
See also ‘Reference Information - Access
Codes’.