Filter
Top Products
Call Functions
Copyright © 2004 Nokia. All rights reserved. 15
Speed Dialling a Phone Number
If you have assigned a phone number to one of
the speed dialling keys ( to ), you can
call that phone number in either of the following
ways:
• Press the corresponding speed dialling key
and press .
• If the Speed Dialling function is set to on (see
Menu 4-3-3): Press and hold the correspond-
ing speed dialling key ( to ) until
the call is started.
NOTE: Pressing and holding
dials your voice mailbox number.
Answering a Call
1 To answer the call, press .
2 Press to end the call.
TIP:
To reject an incoming call, press
. If the ‘Divert when busy’
function is activated to divert the
calls, for example to your voice mail-
box, rejecting an incoming call will
also divert the call. See chapter 10 -
‘Call Divert (Menu 5)’.
NOTE: If more than one name is found
in the Phone Book with the same last
seven digits as the caller’s phone
number, only the caller’s phone num-
ber will be displayed, if this is avail-
able.
Call Waiting
This network service allows you to answer an in-
coming call while you have a call in progress if
you have activated the menu function Call Wait-
ing Options (Menu 4-3-4).
1 Press Answer or . The first call is put on
hold. To reject the new call, press Options,
choose Reject and press Select.
2 To switch between the two calls, press Swap
or .
3 To end the active call, press .
In-Call Options
Your phone provides a number of control func-
tions that you can use during a call. You cannot
utilise all of these functions at all times. Many of
the In-Call options are network services. By
pressing Options during a call the following
In-Call options may be available:
Hold or Unhold to hold or release a call
New Call to make a call when you
have a call in progress
Send DTMF to send DTMF tones
End all calls to end all calls
Names to access the Phone Book
Menu to access menu functions
Mute to mute the phone’s micro
phone
Transfer to connect a call on hold
with an active call and to
disconnect you from both
calls
Making a Conference Call
This feature allows up to six persons to take part
in a conference call (network service).
1 While in a call, press options and choose
New Call. The first call is put on hold.
2 To join the first conference participant into
the call, press Options, choose Confer-
ence and press Select.
3 To add a new participant to the call, repeat
steps 1 and 2.
4 To drop a single participant from the call,
press Options, choose Private and
press Select. Select the participant that
you want to drop and press OK. Then press
.
5 To end the conference call, press .