Nokia 8800 Cell Phone User Manual


 
Getting started
12
Check the model number of any charger before use with this device. This device is
intended for use when supplied with power from the ACP-12 charger.
For availability of approved enhancements, please check with your dealer.
1. Connect the charger to a standard
wall outlet.
2. Insert the charger plug into the
round jack in the bottom of the
phone. If the battery is completely
empty, it may take a few minutes
before the charging indicator
appears on the display or before
any calls can be made.
3. Disconnect the charger from
the phone when the battery is
fully charged.
You can use the phone while the charger is connected. The charging time depends
on the charger and the battery used. For example, charging a BL-5X battery with
the ACP-12 charger takes approximately 1 hour and 5 minutes while the phone is
in the standby mode.
Turn the phone on and off
Press and hold the power key as shown. If the phone asks for a
PIN, enter the code, and select OK.
When you turn on your phone for the first time, the phone is in
standby mode (see "Standby mode" on page 15) and a query
appears, asking for the configuration settings from your service
provider (network service). Confirm or decline the query.
See "Configuration settings service" on page 9.
Open the keypad
1. Hold the phone in one hand.
2. With the other hand, press your thumb on the part of the
phone that is below the display screen.
3. Push the top part of the phone (slide) upwards, as shown in
the illustration.