Filter
Top Products
[ 125 ]
Menu functions
• Activate IR in your phone by pressing
Menu
12-1
(
Connectivity >
Infrared
) at the Start screen.
• The user of the other device should activate IR as well.
If data transfer is not started within two minutes after the activation of
the IR port, the connection is cancelled and has to be started again.
IR CONNECTION INDICATOR
• When is shown continuously, the IR connection is activated and
your phone is ready to send or receive data through its IR port.
• When blinks, your phone is trying to connect to the other device
or a connection has been lost.
Using data communication applications
For information on using a data communication application, refer to the
documentation provided with the application.
If you use an IR connection, activate the IR connection in your phone by
pressing
Menu 12-1
(
Connectivity > Infrared
). Also, make sure that the
connection is active in your PC.
If you use the DKU-5 data cable:
1
Connect the cable to the USB port on the back of your computer and
to the connector on your phone.
2
Start using the data communications application on the computer.
Note:
Making or answering phone calls during a computer
connection is not recommended as it might disrupt the operation.
For better performance during data calls, place the phone on a stationary
surface with the keypad facing downward. Do not move the phone by
holding it in your hand during a data call.
•(E)GPRS
General packet radio service (GPRS) is a technology used to send and
receive data in short bursts or packets over the wireless network. With
GPRS, you can stay connected to the Internet and allow faster downloads
without completing a dial-up connection. Applications using GPRS