Pantech PG-3300 Cell Phone User Manual


 
If you experience any problem while using your mobile
phone, please refer to the following checklist. If the
problem still persists, contact your dealer or nearest
service centre.
When the “Insert SIM Card” message appears:
Make sure the SIM card is correctly installed. Check to
see if the SIM card is working properly. If it does not work,
try to clean the contact points of the card. If it is out of
order, take it to the nearest service centre.
When the “Handset locked enter password”
message appears:
Enter the phone password. If you cannot remember the
password, contact the nearest service centre.
When the “Enter PIN1” message appears:
InputPIN1. If you cannot remember it, contact the nearest
service centre. You can still receive calls even if your
mobile phone becomes locked after entering the incorrect
PIN1 on three consecutive attempts.
When the “No service” or “Network failure”
message appears:
Check the SSI (Signal Strength Indicator) state. If you
cannot make a connection in underground areas or in
buildings where signal strength may be low, try moving
to another place. If you still cannot make a connection,
contact the nearest service centre.
When audio quality is poor:
End a call and try again.
When the other party cannot hear you speaking:
Your phone may be set to MUTE. Disable the MUTE
function.
When battery lifetime is shorter than usual:
This may happen when you are in an area with low
signal strength. Turn off your phone when it is not in use.
Change the battery when battery energy is exhausted.
When your mobile phone does not turn on:
Make sure your battery is charged. Check to see if your
phone works while recharging the battery.
When you are unable to send a message:
Either you are not registered to receive an SMS service,
or you may be in an area where your network service
provider cannot provide such a service.
When you are unable to make a call:
Your phone may be set to “fixed dial.” Cancel the “fixed
dial” function.
Troubleshooting checklist
100
060602_PG-3300_EN(00)�‚�¬.indd 100 2006.6.8 4:53:54 PM