Filter
Top Products
90 Operator services
Conference
. Repeat the above process until five mem-
bers are connected.
If there is an incoming call during the conference call
and there are less than five members, you can accept
this new call by pressing
,
. Press
,
again and
then select
Conference
to add this member to the con-
ference call. If there is an incoming call during a con-
ference with five members already connected, you can
answer this new incoming call, but not add it to the
conference.
While a conference call is in progress, press
,
to ac-
cess the
Conf. members
options. Disconnect a member
of the conference by selecting
Remove party
and press-
ing
,
to confirm, or select
Private call
to have a pri-
vate call with this member only (other members are put
on hold).
Subscription dependent
You can connect an active call and a call on hold. You
are disconnected when the transfer is completed. Dur-
ing a call press
,
, select
Tra n sfe r
and press
,
.
This feature is different from the Call forward, which
takes place before you pick up the call (see page 78).
Explicit call transfer
Philips535_EMEA_GB_4311 255 57351.book Page 90 Mardi, 25. novembre 2003 9:25 09