Filter
Top Products
SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SRP
30 1725-36030-001_B.doc
WPA2-PSK The security features of WPA2 using PSK are available and
may be used if supported by the access points in the facility. Select
either
Passphrase and enter a passphrase between 8 and 63 characters
in length or
Pre-Shared Key and enter the 256-bit key code.
WPA-PSK The security features of WPA (Wi-Fi Protected Access)
using PSK (pre-shared key) are available and may be used if
supported by the access points in the facility. Select either
Passphrase
and enter a passphrase between 8 and 63 characters in length or
Pre-
Shared Key
and enter the 256-bit key code.
Consult the Configuration Note for the APs installed in your facility
for information on which of the WPA versions are recommended by
Polycom. Configure the recommended version on the AP and select
the corresponding option on the Admin menu.
Cisco FSR (Fast Secure Roaming) In order to provide the highest level
of security without compromising voice quality on Cisco Aironet
wireless LAN APs, Polycom and Cisco Systems have cooperated to
implement the Fast Secure Roaming mechanism. FSR is designed to
minimize call interruptions for SpectraLink 8000 System handset
users as they roam throughout a facility. Existing Aironet 350, 1100
and 1200 APs may require a firmware upgrade to support FSR. Cisco
FSR requires advanced configuration of the Cisco APs in your site.
See your Cisco representative for detailed documentation on
configuring your APs and other required security services on your
wired network. To configure Cisco FSR in your SpectraLink
8020/8030 Wireless Telephone, you must enter a RADIUS server
username and password into each handset.
Username Enter a username that matches an entry on your
RADIUS server Usernames are alphanumeric strings and can be
entered using the alphanumeric string entry technique.
Password Enter the password that corresponds to this username.
Regulatory Domain/802.11 Config/Transmit Power
Regulatory domain, 802.11 configuration and transmit power are
interdependent. See Appendix A: Regulatory Domains for regulatory
domain setting specifications. Polycom recommends that you check
with local authorities for the latest status of national regulations for
both 2.4 and 5 GHz wireless LANs.
FCC requirements dictate that the menu for changing the regulatory
domain be available by password, which in our case is the
LINE key.