Filter
Top Products
Safety 127
Cautions
Any changes or modifications to your phone not expressly approved in this
document could void your warranty for this equipment, and void your
authority to operate this equipment. Only use approved batteries, antennas
and chargers. The use of any unauthorized accessories may be dangerous
and void the phone warranty if said accessories cause damage or a defect to
the phone.
Although your phone is quite sturdy, it is a complex piece of equipment and
can be broken. Avoid dropping, hitting, bending or sitting on it.
Information to User
This equipment has been tested and found to comply with the limits of a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation; if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
ⅷ Reorient / relocate the receiving antenna.
ⅷ Increase the separation between the equipment and receiver.
ⅷ Connect the equipment into an outlet on a circuit difference
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rates (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy
absorbed in the head of a user of a wireless handset.
The SAR value of a phone is the result of an extensive testing, measuring and
calculation process. It does not represent how much RF the phone emits. All
phone models are tested at their highest value in strict laboratory settings.
But when in operation, the SAR of a phone can be substantially less than the
level reported to the FCC. This is because of a variety of factors including its
proximity to a base station antenna, phone design and other factors. What is