Filter
Top Products
N
o
t
for
C
o
m
m
e
r
c
i
a
l
U
s
e
WAP Browsing 69
Preparing Your Phone for WAP
Before you can start using the WAP browser, you need to
make sure that your access settings are set correctly. You
need to set up your User ID and WAP Gateway address.
Depending on your network service provider, you can
receive the access settings you need in different ways.
• When you buy your phone together with a WAP
subscription. Your service provider has already entered
all the WAP settings you need.
• Manually. Your service provider will give you the
settings you need. You can then enter them yourself.
Entering the WAP Settings Manually
The WAP settings you enter will be associated with one
of the WAP profiles. If you want to use more than one
WAP profile, you need to specify the settings for each
profile. See “Using WAP Profiles” on page 72.
Setting up a Data Connection
1 Scroll to
Browser, Select, WAP Settings, Select.
2 Select a WAP profile, Select.
3
Access, Select, WAP Gateway, Select, User ID,
Select.
4 Enter the User ID to your WAP gateway, Select.
5 Select
Password, Select.
6 Enter the password to your WAP gateway, Select.
7 Select
IP Address, Select.
8 Enter the IP address to your WAP gateway, Select.
An IP address looks something like this: 123.4.67.120.
You have now entered the settings you need to start
browsing the internet.
Note!
Please refer to the information provided by
your service provider before you enter your
settings.
Note!
An IP address consists of four groups of digits,
with a maximum of three digits in each group.
If one of your digit groups consists of only one
or two digits, you have to enter a zero (0) in
front of the original digit for each digit that is
missing. For example, if you were to enter the
IP number above, 123.4.67.120, you should
enter 123.004.067.120.