Filter
Top Products
N
o
t
for
C
o
m
m
e
r
c
i
a
l
U
s
e
80 Making Data and Fax Calls
1 Connect your computer to your
phone with your DRS-11 serial
interface cable. The cable has a plug
on one end that matches the
receptacle on the bottom of your
mobile phone. The other end of the
cable has a 9-pin female connector that matches the
standard 9-pin serial interface port connector. Connect
one end of the cable to your mobile phone and the
other end to the serial port on your computer.
2 Install your modem control software (driver).
The modem driver that you need for your mobile
phone is available at www.SonyEricsson.com
. Refer
to this web site for help with installing drivers for
different operating systems.
3 Set up your data access software according to the
instructions supplied on www.SonyEricsson.com
.
Operation
Making and Receiving Data and Fax Calls
When your phone and computer are properly set up, you
can send a fax, or initiate data calls, as with any other
modem.
Review the instructions from your mobile service
provider that describe the procedures and rules for
making and receiving data calls in your area.
Disconnecting
Disconnect your mobile phone from your computer by
disconnecting the cable from your phone and from the
serial port on your computer.
Use with Other Sony Ericsson or Ericsson Chargers
To charge your phone’s battery with a rapid or travel
charger during data operation, do the following:
Note!
If you are trying to connect to a 25-pin serial
interface port on your computer, you will need
an adapter. You can purchase a 25-pin serial
interface port adapter at most computer supply
stores.
Note!
To avoid unnecessary airtime charges,
terminate your data calls, by pressing the No
key, as soon as you have finished transferring
files.