Filter
Top Products
SECURITY MENU
▼
Change Password Menu
1) To go to the security menu
from standby, press
menu
.
2) Press ▼ three times.
3) Press
menu
.
4) Press
menu
again.
5) To change the four-digit password,
enter the current
four-digit password.
The factory pre-set password is 0123.
• You must enter the correct password within ten
seconds. If not, the CHANGE PASSWORD prompt appears.
• If you enter the wrong password, the
INCORRECT PASSWORD message appears followed by the
PASSWORD prompt. These messages will repeat until you
enter the correct password or press
end
.
6) Enter a new four-digit password.
7) To confirm, reenter the
new password.
8) The display returns to standby.
25
MENUS
HINT
To exit the change
password menu,
press
end
.
HINT
To move to a menu,
use either the ▲ (up)
or ▼ (down) key.